High-lifter Max Clearance Series Trailing Arm Kit for Polaris Manual de usuario descargar pdf (Pagina 5)

9. Locate the arm for the side you are working on and install the new heim joint and jam nut. You

will need measure the distance from the eye of the heim joint to the hole located on the arm.

The distance needs to measure 34 3/16”. Adjust the heim joint to achieve the proper distance

then set the distance by tightening the jam nut.

10. Once you have set the length and tighten the jam connect the new trailing arm to the UTV.

11. Insert two heim adapters into the heim joint.

12. Connect the heim joint end to the frame using the stock nut and bolt that held the factory

trailing arm in place.

1 2 3 4 5 6 7 8 9

Sin comentarios

High-lifter Max Clearance Series Trailing Arm Kit for Polaris Manual de usuario Pagina 5